Venta technician checking refrigerant pressures on a Goodman condenser in Southern California

Goodman AC No-Cool & No-Start · Coil · Refrigerant · Compressor

Goodman® AC Not Cooling in Southern California

A Goodman that runs but blows warm is usually a dirty condenser coil, a refrigerant leak, a weak compressor, or a frozen coil — and a Goodman that will not start at all is usually a capacitor, contactor, or control fault, not a dead system. Venta is an independent Goodman and Amana® repair-and-installation contractor who diagnoses the actual cause with manifold gauges and amp-draw readings rather than adding refrigerant and leaving, across the lineup (GSXC18, GSX16, GSX14, plus the matching Amana units) in Los Angeles, Orange, San Bernardino, Riverside, and Ventura counties. Flat $89 diagnostic, credited to the repair. CSLB #1138898 (C-20).

Phones answered 24/7. Same-day dispatch in business hours, typical arrival 2–3 hours. Call (424) 766-1020.

“It runs but it is not cold,” and “it will not come on at all” are the two most common warm-weather calls we field, and both are routinely misdiagnosed as low refrigerant or a dead compressor. They rarely are. This page is the Goodman-specific companion to our general AC repair service and our Goodman AC repair page. Common failure modes have dedicated guides: compressor replacement, refrigerant leak, fan not spinning, leaking water, contactor replacement, and making noise.

Why a Goodman runs but will not cool

From thousands of no-cool calls across SoCal, the causes cluster like this:

  • Dirty condenser coil — the most common cause in a heat wave. The outdoor coil cannot reject heat, so the system loses ground as the day gets hotter. A coil cleaning plus a capacitor solves more no-cool calls in Pasadena and the Inland Empire than any other repair, often under $400 total.
  • Refrigerant undercharge from a leak — not consumed, so low charge means a leak. Detection $245–$485; the fix depends on where it is.
  • Weak compressor — high amp draw, cannot pull pressures down. Confirmed with gauges before we ever quote one.
  • Frozen evaporator coil — ice from restricted airflow or low charge. Shut it off, thaw it, fix the restriction.
  • Failed run capacitor — the unit is barely starting or the fan is struggling. Full detail on our Goodman capacitor replacement page.

The full diagnostic walkthroughs are in our AC running but not cooling, why is my AC not blowing cold air, and frozen evaporator coil guides.

Why a Goodman will not turn on

A no-start is usually cheaper than people fear. The common causes: a tripped breaker, dead thermostat batteries, a failed low-voltage transformer, a blown 24V control-board fuse, or a contactor welded open. If the outdoor unit hums but the fan will not spin, that is a failed run capacitor — shut the breaker so you do not cook the compressor. The Goodman indoor control board flashes a diagnostic LED code through the sight glass that points to the subsystem, which we read against the unit’s legend. The step-by-step is in our AC not turning on guide, and the code reference is on our Goodman error codes page.

Why we will not just add a pound and see

Topping off a leaking Goodman is a $200 bill that lasts six weeks, and it is illegal to add refrigerant without EPA certification. More importantly, it leaves the actual problem in place. We find the leak with electronic detection and a gauge set, then quote the real repair. Newer Goodman systems use R-454B (the 2025-and-later refrigerant); systems through 2024 are R-410A, and a pre-2010 unit is R-22 at $150–$300 per pound — on which a leak repair rarely beats replacement, especially on a value-tier unit. A clogged condensate drain is its own common no-cool culprit, covered in our clogged AC drain line guide.

Why it fails when it does in SoCal

The microclimate sets the pattern. Inland in Pasadena, Burbank, the Inland Empire, and the Conejo Valley, a marginal system that cools fine at 80°F loses the fight at 104°F — dirty coils and weak capacitors show worst under peak load, and single-stage GSX13/GSX14 units have no middle gear to fall back on. On the coast in Santa Monica, Manhattan Beach, and Malibu, salt air corrodes condenser electricals earlier in the unit’s life. Either way, an annual coil cleaning before summer is the cheapest insurance against a peak-heat no-cool call.

Goodman no-cool repair pricing

Flat-rate, parts and labor, from our SoCal service tickets. Diagnostic is $89 ($149 after-hours), credited to the repair if you proceed:

Goodman AC repair Typical cost
Diagnostic (waived with repair)$89 / $149 after-hours
Dual-run capacitor$185–$295
Contactor$165–$285
Refrigerant leak detection$245–$485
Condenser fan motor$485–$795
TXV (GSX16 / GSXC18)$585–$895
Compressor (out of warranty — we quote replacement)$2,400–$4,200

These are the same flat rates on our Goodman AC repair page. A registered Goodman still carries labor on warranty parts; we confirm coverage before ordering.

Repair or replace

A no-cool call on a newer Goodman is almost always a straightforward repair — clean the coil, replace a capacitor, fix a leak. The replace conversation starts when the cause is a failed compressor or a coil leak on an older unit, and the budget angle tips it sooner: a $2,400–$4,200 compressor on a 12-plus-year value-tier R-22 system rarely beats a $4,500–$7,500 value-tier replacement — especially on a rental or ADU. We model the repair against a written replacement quote so you decide on real numbers. See AC installation when replacement is the call, and the full lineup on our Goodman brand page.

Frequently asked questions

Why is my Goodman AC running but not cooling? +
My Goodman AC will not turn on at all — where do I start? +
Is low refrigerant the reason my Goodman AC is not cooling? +
How much does it cost to fix a Goodman AC that is not cooling? +
My Goodman has ice on the lines but is not cooling — what do I do? +
Why does my Goodman cool fine in the morning but quit in the afternoon heat? +
Does this cover Amana air conditioners too? +